MULTIPLE EFFECT DISTILLER

OPERATING SYSTEM

WFI by MED – How the Multiple Effect Distiller works

Multiple Effect Distiller Operating System. MED process from BRAM-COR works as follows: heating for evaporation and cooling for condensation processes are performed by double tube sheet (DTS) exchangers. Condensation is achieved by means of the thin-falling film technology.

Consequently, the process is repeated in each column: the higher the quantity of columns  the lower overall the consumption of the equipment. Therefore, the quantity of columns does not influence the quality nor the output of the equipment.

Furthermore, a special labyrinth-separator installed at the top of each column separates the steam generated by the evaporation process from entrained substance in the steam itself. The result is a pure, “dry”, pyrogen-free steam, condensed in compendial Water for Injection.

The first column of the Multiple Effect Distiller may be used to produce alternatively or even at same time, also Clean Steam.

Note: Preheaters will make the Multiple Effect still operate more efficiently in regards to steam and water consumption, but are not always a standard feature. A preheater can be installed prior to the first column for additional benefit, or prior to all columns for maximum benefit. Evaporators will be located internal or external to the column.

Further information about BRAM-COR Multiple Effect Distillation:

 www.multiple-effect-water-distiller.com

Site sponsored by BRAM-COR Italy | waterforinjection.com Cookie Policy